Buy certified lights rated for outdoor use
Light strings are rated for indoor or outdoor use, and Health Canada says indoor lights should only be used inside. Look for a Canadian certification mark on the package or label, such as CSA, cUL or cETL. The ESA says the mark shows the product was tested to the applicable standards. It also suggests buying electrical products only from retailers you trust, since typos in the product information can be a sign of a counterfeit. If a product has no certification mark, the ESA's advice is not to use it: return it and report it to the ESA. Health Canada suggests checking the federal recalls and safety alerts database before you buy or use lights, and CCOHS recommends LED lights because they give off less heat and use less electricity.
Check every string before it goes up
Lay the lights out and look them over on the ground first. CCOHS lists the signs of a worn string or cord: frayed wires, bare spots, gaps in the insulation, cracked sockets or plugs, heavy kinking, or a cord that feels warm after it has been on for a while. Health Canada says to throw out strings and extension cords with exposed wires, loose connections or broken sockets, and to replace broken or burned-out bulbs with the type the manufacturer recommends. CCOHS adds that every socket should have a bulb in it.
Plug in to a GFCI outlet and spread the load
The ESA, Health Canada and CCOHS all say to use a Ground Fault Circuit Interrupter (GFCI) outlet for outdoor connections. Don't put too many lights on one outlet: Health Canada notes that overloaded circuits can overheat, and the ESA says fuses that blow often or breakers that keep tripping are warning signs. A few more cord rules from the ESA and CCOHS:
- never remove the third (grounding) prong from a plug;
- use outdoor-rated extension cords outside;
- don't run cords through windows or doorways, or under carpets where they can be pinched or damaged;
- keep connections off the ground and away from puddles, driveways and walkways.
Hang them with clips, three strings to a run
Read the package for how many strings can be joined end to end. The ESA's guideline is no more than three. Hang the lights with clips made for the job: CCOHS warns that nails, tacks and staples can cut into the insulation and cause corrosion or a short circuit. The ESA also says to keep bulbs away from cords, wires, cloth, paper and other materials that can burn.
Look up before you set up the ladder
Most roofline and tree lighting means a ladder. The ESA says to check for overhead power lines before you use a ladder or decorate an outdoor tree, and to stay at least 3 metres away from them. The CCOHS ladder tips:
- set the feet on firm, level ground that isn't slippery, which in December can mean clearing snow and ice first;
- pick a stepladder about 1 metre shorter than the highest point you need to reach, open it fully, and don't stand on the top or the pail shelf;
- run an extension ladder up past the eavestrough and set it at a 4 to 1 ratio, about 75 degrees from the ground;
- keep three points of contact: two hands and a foot, or two feet and a hand;
- climb down and move the ladder instead of leaning out or "walking" it while you stand on it, and never leave it unattended.
Turn them off, then take them down
All three sources say to turn holiday lights off when you go to bed or leave the house. An outdoor timer takes care of that for you. The ESA adds that holiday decorations are not meant for year-round use, so take them down once the season is over, and keep an eye on pets that might chew on cords.
When to call us
If you would rather stay off the ladder, iTrim4U installs Christmas lights on homes and commercial properties across Durham Region and Toronto from our office in Whitby. We plan the look with you, put it up with our own lights, extension cords and timers, look after it through the season, and take everything down and store it afterwards. See Christmas lighting services or the page for your area.
Sources